Table des Matières
Publicité
Ground/Shield
Pin 1
Data (-) signal
Pin 2
Data (+) signal
Pin 3
Do not use
Do not use
Setting up a DMX Serial Data Link
1. Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the controller.
2. Connect the end of the cable coming from the controller which will have a (female) 3 pin connector to the input
connector of the next fixture consisting of a (male) 3 pin connector.
3. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.
Master/Slave Fixture Linking
1. Connect the (male) 3 pin connecter side of the DMX cable to the output (female) 3 pin connecter of the first
fixture.
2. Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connecter to the input
connecter of the next fixture consisting of a (male) 3 pin connecter. Then, proceed to connect from the output as
stated above to the input of the following fixture and so on
Often, the set up for Master-Slave and Stand-alone operation requires that the first fixture in the chain be initialized
for this purpose via either settings in the control panel or DIP-switches. Secondarily, the fixtures that follow may also
require a slave setting. Please consult the '' Operating Instructions» section in this manual for complete instructions
for this type of setup and configuration.
4. OPERATING INSTRUCTIONS
4.1 Navigation through the Control Panel
Access control panel functions using the four panel buttons located directly underneath the LCD Display.
Button
Function
<MODE/ESC>
Used to access the menu or to return to a previous menu option
<UP>
Scrolls through menu options in ascending order
<DOWN>
Scrolls through menu options in descending order
<ENTER>
Used to select and store the current menu or option within a menu
When a menu function is selected, the display will show immediately the first
available option for the selected menu function. To select a menu item, press <ENTER>.
4.2 Menu map
Press the <MODE/ESC> button repeatedly until you reach the desired menu function. Use the <UP> and <DOWN>
buttons to navigate the menu options. Press the <ENTER> button to select the menu function currently displayed or
to enable a menu option. To return to the previous option or menu without changing the value, press the
<MODE/ESC> button. After a few seconds, the LED Display will back during operation until another button is pressed.
5. Manual setting menu mode:
Mode
Auto
Sound
©Copyright LOTRONIC 2015
Pin1
Pin 2
Pin 3
Do not use
Do not use
Program
Description
Au-1
Auto program 1
Au-2
Auto program 2
Au-3
Auto program 3
So-1
Sound program 1
LMH250-RC
Page 4
Publicité
Table des Matières
