Ribimex Ribitech PRIAF70 Traduction Des Instructions D'origine page 17

There is the need to identify safety measures to protect the operator that are based on an estimation of
exposure in the actual conditions of use (taking account of all parts of the operating cycle such as the
times when the tool is switched off and when it is running idle in addition to the trigger time).
15. WARNING
A certain level of noise emitted from this machine is not avoidable.
Plan noisy work according to local laws and at specific times.
Keep rest periods and if necessary restrict the working hours to a minimum.
For your own personal protection and the protection of bystanders have suitable hearing protection
worn.
IV- GETTING STARTED
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
4.2- Presentation
The sharpening tool PRIAF716 / 310146 is delivered with two grinding wheel heads: one for
3-10mm and one for 8-16mm.
4.3- Changing the grinding wheel head
1- Unscrew screw (18 – Fig.2)
2- Remove already fitted grinding wheel head
3- Insert the other grinding wheel head (Fig.3)
(Properly align the head with the compartment)
4- Tightly fit screw (18 – Fig.2).
Fig.2 Fig.3
4.4- Set up
Place the tool on a solid, flat and stable surface near a power supply.
Plug tool to power supply.
Note: make sure that the tool is securely installed to prevent slipping during operation.
4.5- Starting and Stopping (ON/OFF switching)
The switch (24) is located on the front panel of the tool.
To start the machine: press the switch to [I] (= ON position).
To stop the machine: press the switch [0] (= OFF position).
V. OPERATION
5.1- Intended use
- The product is intended for indoor domestic use.
- The product is intended for sharpening metal drill bits within the limits of the sharpener.
- This power tool may not be used to do other things outside of the described scope.
- Do not use the machine for unsuitable purposes (for ex. Sharpening blades...)
Page 17 / 30