F.Bertazzoni P905INE Notice D'utilisation page 14

Fitting - installing:
The cut out sizes are:

Ensure that there is a distance of 50 mm between the hob and the wall or sides.
 The hobs are classified as "Y" class for heat protection. Ideally the hob should be
installed with plenty of space on either side. There may be a wall at the rear and tall
units or a wall at one side. On the other side, however, no unit or divider must
stand higher than the hob.
 The piece of furniture or the support in which the hob is to be fitted, as well as the
edges of furniture, the laminate coatings and the glue used to fix them, must be able to
resist temperatures of up to 100 °C.
 The mural rods of edge must be heat-resisting.
 Materials which are often used to make worktops expand on contact with water. To
protect the cut out edge, apply a coat of varnish or special sealant. Particular care must
be given to applying the adhesive joint supplied with the hob to prevent any leakage
into the supporting furniture. This gasket guaranties a correct seal when used in
conjunction with smooth work top surfaces.
 Not to install the hob to the top of a not ventilated oven or a dishwasher.
 To guarantee under the bottom of the hob casing a space of 20 mm to ensure a good
air circulation of the electronic device.
 If a drawer is placed under the work, avoid to put into this drawer flammable objects
(for example : sprays) or not heat-resistant objects.
 The safety gap between the hob and the cooker hood placed above must respect the
indications of the hood manufacturer. In case of absence of instructions respect a
distance minimum of 760 mm.
 The connection cord should be subjected, after builting, with no mechanical constraint,
such for example of the fact of the drawer.
14