Table des Matières
Publicité
Security / Start-up / Operation
Do not use the cables to carry the device or
pull it. Always disconnect the device by
pulling the plug, do not pull the cable.
Operate the device only when it is not dam-
aged.
Do not operate the device when it was
dropped or damaged otherwise.
The device shall not be dismantled, repaired
independently or modified (changed).
All repairs on the device have to be carried
out through a qualified electrician. There are
no exchangeable parts inside the device.
Before you finally delete errors from the error
memory of the OBD II diagnostic device
OL 8000, all errors on the vehicles should be
fixed.
Take care for a safe position when resting
the device. Route the connection cable in
such a way that it does not disturb the
check of the vehicle. Do not lead the cable
along sharp edges or corners and hot surfaces.
The OBD II diagnostic device OL 8000 is not
suitable for the permanent installation in a
vehicle. Do not operate the device while
driving.
Do not connect other cables to the device.
Carry out the check with the OBD II diag-
nostic device OL 8000 only in a safe environ-
ment. Keep away clothing, hair, limbs and
the OBD II diagnostic device OL 8000 away
from moveable or hot engine parts.
During the usage of the OBD II diagnostic
device OL 8000 the working area must be
well ventilated.
Comply with safety regulations when the
vehicle is jacked or is positioned on a lifting
platform or similar.
Do not use other measuring devices on the
vehicle during the use of the OBD II diag-
nostic device OL 8000.
Attention, high voltage in the area of the
ignition coils, distributor cap, ignition cable,
spark plugs and electrical components in the
vehicles.
Check if the vehicle is suitable for diagnosis.
Connect the OBD II diagnostic device
36
GB
OL 8000 with the vehicle only when the
ignition is turned off.
The deletion of error codes does not rectify
the error on the vehicle. These error codes
can be displayed again, until the damage is
repaired by a garage. Let a specialised garage
repair the malfunction on the vehicle.
Start-up / Operation
Analyse error codes
The enclosed software CD covers most of the er-
ror codes displayed. You will receive information
on more recent and some special error codes
(mainly „B", „C" and „U") either via internet
search engines (Search: „OBD 2") or from your
specialised dealer
Publicité
Chapitres
Table des Matières
