Single Control Protocol; Single Control Personality; Single Control Start Address; Single Control Universe - Chauvet Professional Maverick MK3 Wash Manuel D'utilisation

Single Control
In Single Control mode, the Maverick MK3 Wash is controlled by a single protocol input. Choose from
DMX, Art-Net™, sACN, or WDMX. In this mode, the four personalities available are: Basic (21 channels),
Standard (129 channels), Advanced (243 channels), and Tour (297 channels).

Single control protocol

To select the Single Control protocol, follow the instructions below:
1. Press <MENU> repeatedly until the
2. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Control Settings, or touch the display
where it says Control Settings.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP> or <DOWN> to select Single Control, or touch the display where it says Single
Control.
5. If using the buttons instead of the touchscreen, press <ENTER>.
6. Use <UP> or <DOWN> to select from DMX, ArtNet, sACN, or WDMX, or touch the display where
it says the desired protocol option.
7. If using the buttons instead of the touchscreen, press <ENTER>.

Single control personality

To select the Single Control personality, set the Protocol, then do the following:
1. Use <UP> or <DOWN> to select Personality, or touch the display where it says Personality.
2. If using the buttons instead of the touchscreen, press <ENTER>.
3. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select from Basic (21-channel), Standard
(129-channel), Advanced (243-channel), or Tour (297-channel), or touch the display where it
says the desired personality.
4. If using the buttons instead of the touchscreen, press <ENTER>.
For WDMX control, ensure the antenna is raised, and there are no obstructions
between the controller and the product. See
information.

Single control start address

To set the starting address of the Single Control mode, set the Protocol, then follow the instructions below:
1. Use <UP> or <DOWN> to select Start Address, or touch the display where it says Start Address.
2. If using the buttons instead of the touchscreen, press <ENTER>.
3. Enter the starting address (1–512) with one of the following methods:
• Type the address number using the number pad that shows on the touchscreen display.
• Using the buttons (or the button icons on the sides of the display):
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.

Single control universe

To set the Universe address of the Single Control mode when using Art-Net™ or sACN, set the
ArtNet or sACN, then do the following:
1. Use <UP> or <DOWN> to select Universe, or touch the display where it says Universe.
2. If using the buttons instead of the touchscreen, press <ENTER>.
3. Enter the universe address (0–255) with one of the following methods:
• Type the address number using the number pad that shows on the touchscreen display.
• Using the buttons (or the button icons on the sides of the display):
a. Use <LEFT> or <RIGHT> to select the digit to be altered.
b. Use <UP> or <DOWN> to increase or decrease the number value of that digit.
c. Repeat until the address is set as desired.
4. Press <ENTER>.
Page 15 of 323
Home Screen shows on the display. Press <ENTER>.
WDMX reset
Maverick MK3 Wash User Manual Rev. 7
Operation
for troubleshooting
Protocol to