Arktic 233856 Mode D'emploi page 6

Control panel of the appliance
A. Temperature Regulator
The temperature can be adjusted by rotating this
knob in the range of setting 1 to 7.
Setting 0: At "Stop" mode, not operate.
Setting 1: Warmest temperature (- 20°C to -18°C)
Setting 7: Coldest temperature (- 26°C to - 24°C)
Note: The setting temperature will be affected
by the below factor:
• Ambient temperature and humidity of the ap-
pliance
EN
Installation of the appliance
Attention: Any installation, maintenance and repair work should be performed by qualified and authorized
technician only.
• Check to make sure that the appliance is un-
damaged or complete delivery (basket and drain
stopper are included). In case of any damage or
incomplete delivery, DO NOT use the appliance
and contact the supplier immediately.
• Remove all packing material and protective film
(if applicable).
• Let the appliance stand still for at least 3 hours
after installation before putting the appliance into
operation, this is to allow the cooling agent to lev-
el off for optimum efficiency.
• Place the appliance on a dry, level, steady and
safe floor away from any heat source. Recom-
mend to place in an air-conditioned room.
• Avoid expose to direct sunlight or direct source of
heat such as cooker, heater, stoves, etc.
• Make sure that a minimum of 20 cm distance is
kept around all sides of the appliance for ventila-
tion purposes.
6
04
°C
Digital Temperature
Display
4
3
2
1
0
Temperature
regulator dial
• Quantity of the stored food item
• Frequency of opening the lid
We recommend to place the food at the middle
position.
B. Digital temperature display
It shows the current temperature inside the ap-
pliance.
Note: Green dot light ON to indicate the com-
pressor is working.
• Place the appliance in such a way that the plug
is easily accessible and can be quickly removed
from its socket in case of necessity.
• Due to heavy weight of the appliance, it should be
installed and moved by at least 2 persons.
• The inclined angle of the cabinet should not be
over 45° during transportation.
Installation of lid handle
• Get the lid handle, screws and handle cover in-
side the appliance.
• Place the lid handle on the front side of the lid,
aligning the screw holes. Fasten them securely.
• Then, place the handle cover to cover the screws,
bending it slightly and fixing it flat onto the lid
handle.
5
6
7