gourmetmaxx XJ-6K114CO Mode D'emploi page 25

1. Place the raclette device on a stable, heat-resistant surface which is easy to clean.
2. Connect the device to a mains socket that has been properly installed. Ensure that it is not
possible for others to trip over the connected cable.
3. If you have not already done so, position the raclette grill plate correctly on the raclette
device.
10. You can use the wooden spatulas which are supplied to move the food in the little raclette
pans or on the raclette grill plate or scoop the cheese out of the little raclette pans.
11. After you have removed the little raclette pans from the raclette device, only place them
on a heat-resistant surface. Allow the little raclette pans to cool down before you put any
new ingredients in them.
12. If you no longer wish to use the device, switch it off by turning the On/Off switch to the
0 position. The On/Off switch and the control lamp on the temperature controller will go
out when the device is switched off. Then remove the plug from the mains socket.
13. Allow the device to cool down and then clean it (see the "Cleaning" chapter). Do not allow
any food residues to dry on.
4. If you do not wish to use the fondue set, place the hot stone
into the recess in the middle of the raclette grill plate. Make
sure that the smooth side of the stone with the groove is
facing upwards. To this end, follow the instructions in the
"Hot Stone" chapter.
If you wish to use the fondue set, leave the recess in the middle
of the grill plate clear during the heating-up phase.
5. Allow the raclette device to heat up for approximately
10 minutes without any little raclette pans or the fondue pot
before you use it. To do this, move the On/Off switch to the
1 position to switch on the device.
6. Set the temperature controller to the highest setting for
10 minutes. The On/Off switch and the control lamp on
the temperature controller will light up when the device is
switched on.
7. In the meantime, prepare the ingredients for your raclette.
When fi lling up the little raclette pans, take care to ensure
that the food does not touch the heating elements of the
raclette device.
8. Insert the receptacle for the fondue pot into the recess in the
middle of the raclette grill plate and place the fondue pot into
the receptacle if you wish to use the fondue set. When you do
this, follow the instructions in the "Fondue" chapter.
9. As soon as the device has heated up, you can set the
temperature to refl ect your preferences. You can now place
the fi lled little raclette pans for baking into the tray for the
little raclette pans underneath the heating elements and grill
vegetables or meat on the raclette grill plate.
25