Maintenance And Cleaning; Ordering Replacement Parts - Einhell Royal RGS 18 Mode D'emploi

Anleitung RGS 18_SPK7:Anleitung AGSS 18
Once you have removed the blade you will be able to
see the toothed wheels of the gear unit (Fig. 7). Take
care to make sure that no dirt gets into the gear unit
when you change the blade.
When you fit the hedge cutter blade, check the
position of the pin for the eccentric connector (Fig.
7/Item 1).
Take the hedge cutter blade and slide the eccentric
mount (Fig. 8/Item 1) into position so that the pin for
the eccentric connector and the eccentric mount fit
together precisely when assembled. To secure the
hedge cutter blade for cutting, slot it onto the guide
pins (Fig. 7/Item 2) and fasten it in place with the
screws (Fig. 10/ Item 1).
When you fit the grass cutter blade, check the
position of the pin for the eccentric connector (Fig.
7/Item 1) again.
Shift the eccentric mount (Fig. 9/Item 1) on the grass
cutter blade to the left or the right to find the position
at which the pin for the eccentric connector (Fig.
7/Item 1) and the eccentric mount (Fig. 9/Item 1)
match up. Then secure the cutter blade by tightening
the screw again.

8. Maintenance and cleaning

To achieve good results you should keep the blades
sharp at all times. In particular we recommend that
you immediately level off any jags or ridges caused
by stones or the like. The tool should be thoroughly
cleaned both before and after use. A few drops of oil
(e.g. sewing machine oil) will improve the cutting
performance of the blades, but never apply any
grease to the blades. To ensure constant exact
cutting it is also important to remove grass remnants
and dirt from between the upper and lower blade.
Important!
Never clean the tool under running water - and
particularly never with high pressure - because
of the potential danger to persons and property.
Keep your cordless grass cutter and hedge
trimmer in a dry and frost-proof place. Choose a
place that children are unable to enter.

9. Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
05.07.2007 8:38 Uhr Seite 11
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
GB
11