GE 898690 Mode D'emploi page 7

840204201 ENv03.qxd:840152100 Ev01
Operating Instructions
Before plugging in the hand mixer, check that the electrical circuit is not overloaded with
other appliances.
• Make sure the hand mixer is not connected to the wall outlet and the speed control (1)
is set to the O (OFF) position.
• Insert the desired attachment (see the table below for reference).
• Place the ingredients you want to mix into a bowl.
• Connect the power plug (5) to a suitable wall outlet.
• Set the speed control (1) to a desired speed to switch on the appliance. NOTE: Start at
speed 1 and gradually increase to a higher speed, as needed.
• Thoroughly mix the ingredients.
• When mixing is finished, set the speed control (1) back to the O (OFF) position and
unplug the power plug (5) from the wall outlet.
NOTE: The mixer is equipped with a burst button (2). By pressing and holding the burst
button (2) down at any speed, you can add additional power.
WARNING: Do not use the burst button (2) for more than 2 minutes at a time; otherwise
the motor may overheat.
Attachment
Beaters (8)
Dough hooks (12)
Whisk (10)
Milkshake (9)
WARNING: Attachments should be used as a set (2 beaters, 2 dough hooks, 1 whisk,
or 1 milkshake attachment). Do not mix different attachments.
NOTE: You can rest the mixer on the bowl using the bowl rest (6) during periods of
nonuse; for example, when you are adding ingredients to the mixture (ill.
However, never place the mixer on the bowl rest (6) while the appliance is switched
on. Also, make sure that the bowl on which the mixer is resting will not fall over. You
can also rest the mixer on its heel (ill.
8/29/11
OPERATION
How to Install
• Insert one beater (8) into any of the openings (7). Push until it clicks
into place (ill. ).
• Repeat the step above to insert another beater (8).
• Insert a dough hook (12) with a collar disc (11) into the right-side
opening (7). Push until it clicks into place (ill.
• Repeat the step above to insert another dough hook (12).
• Insert the whisk (10) into any of the openings (7). Push until it clicks
into place.
• Insert the milkshake attachment (9) into any of the openings (7).
Push until it clicks into place.
).
9:58 AM Page 7
).
).
7