F - Intercom Panel User Manual; Default Codes; Opening The Electric Strike Plate Or Motor Drive; Code Management - CFI EXTEL Code Guide D'installation Et D'utilisation

F - INTERCOM PANEL USER MANUAL

The Extel Code keypad is touch screen and backlit.

1 - DEFAULT CODES

The default codes are as follows:
• 1 1 1 1 1 1 1 1: administrator code (8 x 1)
• 1 0 0 0: opens the gate motor drive
• 2 0 0 0: opens the electric strike plate
By default, the opening pulses are 1 second for the gate motor drive and 1.1 seconds for the electric
strike plate. These values can be changed but are compatible with the vast majority of strike plates
and motor drives on the market. Consulting the instruction manual for your particular motor drive is
recommended however.

2 - OPENING THE ELECTRIC STRIKE PLATE OR MOTOR DRIVE

Only the first digit in the codes for opening the strike plate and the motor drive differ. To open, the codes
are as follows:
• 1 + "3 to 7 digit code" + "#" = motor drive opening code
• 2 + "3 to 7 digit code" + "#" = electric strike plate opening code
Default:
• 1 0 0 0 # = opens the motor drive
• 2 0 0 0 # = opens the electric strike plate
The "3 to 7 digit code" is the same but may be changed in administrator mode.

3 - CODE MANAGEMENT

In settings, you can exit this mode by waiting for 15s or pressing the # key 3 times.
If you make a mistake with the code, press the * key before entering the code again.
Extel - Code - 720309-720311
EN6