D - Installation; Connecting An Electric Strike Plate; Connecting A Motor Drive; E - Monitor User Manual - CFI EXTEL Code Guide D'installation Et D'utilisation

D - INSTALLATION

3 - CONNECTING AN ELECTRIC STRIKE PLATE

Directly connect the strike plate or lock wires to terminals 7 and 8 on the back of the panel (no polarity
to adhere to).
Note that this function is only valid if the screen is on. The unit may buzz at the time of the command.
For wiring, refer to the reverse of the panel and the diagram in Fig. 7.
Important:
• The maximum distance between the intercom panel and the electric strike plate or electric lock is 50
m maximum. The wire size to be used is 0.75 mm².
• The use of a 12 V/1.1 A max. electric strike plate with WECA mechanical memory (Extel reference
109021 or 109031) or WECA 5001/2 10 SER R1 (reference 150011) is recommended.

4 - CONNECTING A MOTOR DRIVE

Directly connect the strike plate or lock wires to terminals 5 and 6 on the back of the panel (no polarity
to adhere to).
Note that this function is only valid if the screen is on. The panel provides a "dry" contact connection,
without an electric current, to connect to the button for your automated gate. For wiring, refer to the
reverse of the panel and the diagram in Fig. 7.
Important:
• This function is only valid if the screen is on
• The maximum distance between the intercom panel and the gate motor drive is 50 m maximum.
The wire size to be used is 0.75 mm².
• The product has been tested and approved with Thomson "Sésame" or "Swip" gate motor drives
which can be found at maisonic.fr

E - MONITOR USER MANUAL

The Extel Code videophone is controlled through touch-sensitive keys. The button functions vary
depending on the menu accessed. The icons at the bottom of the screen help to guide you as to their use

1 - BUTTON FUNCTIONS

EN4
1 2
Extel - Code - 720309-720311
3 4 5