Waste Disposal; Faults And Failures; Installation And Assembly - AGRICOW Doppia Mode D'emploi

For waste disposal, the brush must be disassembled it all its parts. For dismantling and selection
of parts it is mandatory to use at least type 4 cut resistant gloves in compliance with EN388.
Parts must be handled as waste with th following EWC codes:
In the case of malfunctions, consult the last chapter of this manual "FAULT TREE".
Installation instructions:
Instructions are given below on how to install the double brush.
The brush must be fastened to the wall by a dedicate fixing-system followed by a connection to the electrical
system which must be carried out by qualified personnel.
For any maintenance it is mandatory to use at least type 4 cut resistant gloves in compliance with EN388.
Optimal positioning and stable fastening are particularly important for the correct operation of the Double brush.
It is thus important to ensure that the mounting surface is stable and not exposed to vibrations or movement.
Agricow advises against outdoor installation. Should this be necessary, it is mandatory to shelter the box
containing the electronic board and the box containing the sensor from rain or excessive sunlight.
ATTENTION:
The brushes must be installed with the dedicated differential magnetothermal differential switch (GFI)
Assembly instructions:
The Double Brush is supplied completely assembled and ready for installation.

WASTE DISPOSAL

Article
Iron Parts
Electrical and electronic
Rubber Parts (PPM)

FAULTS AND FAILURES

INSTALLATION AND ASSEMBLY

EWC code
19 12 02
20 01 36
19 12 04
24
DOUBLE BRUSH