How To Connect The Antennae; Where To Place The Receiver; Mains Connection; Audio Connection - Beyerdynamic Opus 100 Mk II Notice D'utilisation

1.2

How to connect the Antennae

Connect the antennae to the TNC sockets
Please note that for diversity operation both antennae have to be connected. A weighting
circuit silently switches the signal with the better S/N ratio to the output.
Important:
Avoid obstacles between antennae and transmitter; otherwise the reception could be
disturbed.
1.3

Where to place the Receiver

• Place the NE 100 S diversity receiver in the same room or area as the transmitters. Ensure
that the NE 100 S is installed as close as possible to the mixing console or amplifier so
that the display can be seen at all times.
• Do not place the NE 100 S receiver near digitally controlled equipment or other sources
of RF interference.
1.4 Connections
• Connect the Audio output to the corresponding input of the mixing console or amplifier.
Use the balanced Audio output
with a balanced input.
• Use the unbalanced Audio output
input of an amplifier.
• Make sure the Low/High switch
Switch to "High", when you connect the receiver to a mixer/amplifier. When connecting
to a guitar amplifier you should choose "High", or the volume may be too low.
Switch to "Low", when you connect the receiver to a microphone input.
Incorrect positioning of the Low/High switch
• Make sure the mains voltage shown on the power supply unit corresponds to the local
mains voltage.
• Connect the power supply unit to the receiver

Mains Connection

and
6
, when you connect the receiver to a mixer/amplifier
7
, when you connect the receiver to the "LINE"
8
9 is switched to the correct position.
can cause distortion.
9
and to AC mains power.
5

Audio Connection

and set them at an angle (60°).
11
25