Configuration - D-Link AirPremier N DAP-3690 Guide D'installation

Configuration

Connect the DAP-3690 to a Local Computer
If you are configuring the DAP-3690 locally (without connecting its power injector to a wired
LAN), connect a PC to the power injector's Ethernet port using a Category 5 Ethernet cable.
1. Assign a static IP address to your PC which is in the same network segment with the
DAP-3690. As the default IP address of this unit is 192.168.0.50, you may choose from
192.168.0.1 to 192.168.0.254, except 192.168.0.50.
2. Test the link status between your PC and the DAP-3690. Start a command prompt and
execute a continuous ping command "ping 192.168.0.50 –t". If ping to the wireless bridge
is successful (as shown below), open Internet browser and enter the bridge's IP address
in the address filed and press Enter.
Note: Considering convenient configuration, it is recommended to configure local and remote DAP-3690
respectively on two computers. TTL time may vary depending on the operating system.
8
D-Link DAP-3690 Quick Install Guide