Configuration; Technical Support - D-Link DAP-3315 Guide D'installation

STEP 3: Connect Grounding Wire
A grounding wire is to protect your device
from lightning strikes and the buildup of
static electricity.
STEP 4: Connect the AP to Your Network
AP
LAN (PoE)
A
POWER IN
C
Router or Switch Computer
This product uses a proprietary PoE design and
4
can only be used with the included PoE injector.
A. Connect the Ethernet cable that is
connected to the AP from STEP 1 to the
POE port on the PoE Injector.
B. Connect an Ethernet cable from a router,
switch, or PC to the LAN port on the PoE
Injector.
C. Attach the power cord to the PoE Injector,
and attach it into an electrical outlet.

TECHNICAL SUPPORT

6  D-Link DAP-3310/DAP-3410 Quick Install Guide
4
POE
PoE Injector
4
LAN
B

Configuration

If you are configuring the AP locally,
connect a PC to the PoE Injector DATA IN
port using an Ethernet cable.
A. Assign a static IP address to your PC
that is in the same network segment as
the device. As the default IP address
of this unit is 192.168.0.50, you may
choose any address from 192.168.0.1 to
192.168.0.254, except 192.168.0.50.
B. Open a web browser and go to
http://192.168.0.50. Enter admin as
your username and leave the password
blank to log in to the web UI. Now you
can configure the AP through the web UI.
dlink.com/support