Makita 3901 Manuel D'instructions page 6

Dust bag
1
2 3
004583
To attach the dust bag, fit it onto the dust nozzle. If the
dust bag becomes an obstacle to your work, turn the
dust nozzle to change the dust bag position.
When the dust bag is about half full, switch off and
unplug the tool. Remove the dust bag from the tool and
pull the bag's fastener out. Empty the dust bag by
tapping it lightly to remove as much of the dust as
possible.
NOTE:
If you connect a Makita vacuum cleaner to your
•
plate joiner, more efficient and cleaner operations
can be performed.
OPERATION
How to make joints
To make joints, proceed as follows:
1. Fit the two workpieces together as they will
appear in the finished joint position.
Corner Joint (Fig. A)
004584
T-Butt Joint (Fig. B)
004585
1. Dust bag
2. Fastener
3. Dust nozzle
Fig. A
Fig. B
Miter Joint (Fig. C)
004586
Frame Joint (Fig. D)
004587
Edge-To-Edge Joint (Fig. E)
004588
2. Mark the center of the intended biscuit slots on
the workpiece using a pencil.
NOTE:
The center of slots should be at least 50 mm (2") from
the outer edge of the workpieces.
Allow 100 mm - 150 mm (4" - 6") between slots in
multiple biscuit application.
3. For Corner Joint and T-Butt Joint only
Clamp the vertical workpiece to the workbench.
004589
6
Fig. C
Fig. D
Fig. E