Metabo PK 250 Mode D'emploi page 10

8.1 Dimensioning
For dimensioning riving knife and blade guard must be in place at all times.
Place roller carriage extrusion into
crosshead plates Secure to crosshead
plates with bolts.
Set hinged backstop to desired
dimension.
Place table onto seats of traversing
saddle and secure with the two clamp
levers.
Flip up backstop and place work onto
table. Start saw and cut edge square.
Set fence close to saw blade, tighten
starknobs.
Pull back sliding carriage with work.
Turn work round by 180° and place
squared edge against backstop. With
second cut cut to dimension.