Bathwater Temperature - Villeroy & Boch Finion Manuel D'installation

1. Release the two screws on the back of the housing.
2. Open the cover and replace the battery.
3. Close the cover again.
Make sure that the seal is located flush with the edge of the housing.
4. Fix the cover again using the two screws.

6.3 Bathwater temperature

Applies only for products with the "Mood Light" function.
Caution!
Material damage as a result of excessively high temperatures!
Temperatures in excess of 50 °C can cause damage to the system and the associated components.
The bath water must not exceed a temperature of 50 °C.
•
www.villeroy-boch.com // V 1.1 // 24.10.2017 //
13