Montage; Mounting - DURAVIT D-Code 740095 Notice De Montage

Table des Matières

Publicité

d 

Montage

1
Sifon montieren.
Gewünschte Wannenhöhe durch Ausrichten der Wannenfüße ermit-
teln.
2
Abstand von 10 mm zwischen Boden und Sifon einhalten.

Wannenfüße einstellen bis der Wannenrand horizontal ausgerichtet
ist.

Kontermutter anziehen.

Zur Installation der Wannenanker die Oberkante der Wanne an der
Wand anzeichnen.

Wannenankerlöcher anzeichnen. Einen Abstand von 70 mm zwi-
schen der Wannenecke und dem Wannenankerloch lassen.

Die 3 Löcher bohren.

Dübel anwenden.

Hinteren Wannenanker befestigen.
10  -
Wannenränder mit einem sauberen Tuch und Haushaltsbenzin von
11
Schmutz, Staub und Fettrückständen befreien.
Den schmalen Streifen an den senkrechten Wannenrand ankleben.
12 Den breiten Streifen umklappen und auf den waagerechten Wannen-
rand aufkleben.
1 Stellfläche von Staub reinigen.
Siphon an Abfluss anschließen.
1 Wannenrand auf Wannenanker auflegen.
1 Wanne mit Wannenanker befestigen.
1 (Siehe Elektroinstallation)
Netzanschluss herstellen. Potentialausgleich anschließen.
12 
MAL_53459/05.08.01
gB 

Mounting

Mount siphon.
Find optimum height for the whirltub by unscrewing feet to the same
height.
Keep a 10 mm gap between the floor and the siphon.
Adjust the feet accordingly to make sure that the whirltub is level.
Tighten the lock-nut.
Mark the upper edge of the whirltub on the wall for the wall brackets.
Mark holes for the brackets. Leave a distance of approx. 70 mm between
the corner of the whirltub and the hole.
Drill the 3 holes.
Insert the raw plugs.
Affix the rear wall bracket.
Clean the surface with white spirit on a clean cloth to remove any dirt,
dust and grease.
Stick the narrow strip of the noise reduction tape (if purchased) to the
vertical edge of the whirltub tray.
Fold the wide strip and stick to the horizontal rim.
Clean floor before placing the whirltub.
Connect the siphon to the outlet.
Position the whirltub on the wall bracket.
Affix the whirltub with the wall brackets.
(See Electrical Installation)
Connect wire from the control unit to the mains connection box and the
equipotential earth wire to the connection point.

Publicité

Table des Matières
loading

Table des Matières