Erie water treatment H2Optimo Instructions D'installation Et D'emploi page 9

PROGRAMMING INSTRUCTIONS -
BASIC SETTINGS

Before entering the programming mode, make sure that
the appliance is in service mode.

In case no button is pressed in a period of 5 min, the
control panel will automatically return to the service mode;
any changes made will NOT be saved!
1. Press the scroll button and hold it for 2 sec until the
display shows:
Language:English
•
Press the up or down
language.
2. Press the scroll button again; the display will show:
Set time:
•
Press the up or down
day.
3. Press the scroll button again; the display will show:
HardUnit:
•
Press the up or down
measure for water hardness. Make sure it is identical
to the unit of measure of the water hardness test kit
or water analysis report that is used to determine the
hardness of the incoming untreated water!
4. Press the scroll button again; the display will show:
Set Hardn: XX °f
•
Press the up or down
of the incoming untreated water.
5. Press the scroll button again; the display will show:
Exit
•
Press the up or down
into the NOVRAM® and exit the programming mode.
ELECTRONIC CONTROL PANEL
button to set the
8:01
button to set the time of
°f
button to set the unit of
button to set the hardness
button to save the settings
Page 9
EN - English