Installation; Wiring Diagrams; Maintenance / Cleaning - Vortice CA MD Série Notice D'emploi Et D'entretien

ENGLISH

Installation

See Figures 6-12.
The images shown are purely indicative.
purpose is to illustrate the main assembly steps for the
entire range.
IMPORTANT: See the "Wiring Diagrams" paragraph
to check the 3 ventilation speeds.
IMPORTANT
If the unit does not have piping connected to the
suction point (free suction) and it is installed at a
height lower than 2.3 m, assembly of the protection
grille - suction side (fig.1) is required.
IMPORTANT
Use of the supplied brackets is optional.

Wiring diagrams

See Figure 13A.
Connection with the optional device upon request is
foreseen to check ventilation speeds (device not
supplied in packaging):
- 13A) Vortice 3-speed selector Code 12.869.
IMPORTANT
Vortice guarantees correct product operation and
control only when paired with the Vortice 3-speed
selector (Code 12.869).
Other types of connection
Alternatively, other connection diagrams are available,
associated to different control modes (devices
provided by the installer).
Connection alternative for new installation
- 13B) Pairing with 3-switch control;
- 13C) Pairing with Electronic dimmer.
Machine replacement on existing system
Connection without modifications to the electrical
system: the same switches as on the existing system
will be used. CAUTION: it will not be possible to
connect all 3 available speeds but only those for which
the electrical system is set up (to be chosen by the
installer):
- 13D) Speed connection: Minimum and Maximum;
- 13E) Speed connection: Medium and Maximum.
CAUTION
Correct operation of ERP 2018 is only guaranteed
when set in compliance with the connection diagram
13A).

Maintenance / Cleaning

Fig 14-17.
Important information
concerning the
Their
environmentally compatible
disposal
This product complies with Directive 2012/19/EU on
the management of waste electrical and electronic
equipment (WEEE).
The crossed-out wheeled bin symbol on
the appliance indicates that, at the end of
its useful life, the product must be taken to
a specialised company for transport and
treatment. This company will take care of
the disposal of the various materials
making up
subsequent proper recycling.
Alternatively, the manufacturer of the appliance is
obliged to take back the product to be disposed of in
exchange for the purchase of an equivalent appliance.
the product and their
11