Others - Pioneer UDP-LX500 Mode D'emploi

Others

08
Problem
Power does not turn on.
The player's power turns
off automatically.
The player's power turns
on automatically.
This unit cannot be
operated.
The player cannot be
operated with the remote
control.
Unit heats up during use.
Input of the connected TV
and AV system switches
automatically.
Settings I have made have
been cleared.
USB (external storage)
device does not work
with this player properly.
58
En
Check
Is the power cord
properly connected?
Is Auto Power Off set to 15
min or 30 min?
Is Control set to On?
Is Control set to On?
Are you operating the
remote control from a
point too far away from
the player?
Are the batteries dead?
Is Control set to On?
• Have you disconnected
the power cord while the
player's power was on?
• Has there been a power
failure?
Is the USB device
properly connected?
Is the USB device
connected via an
extension cable?
Is the external storage
device connected to the
USB port via a memory
card reader or USB hub?
Does the external storage
device contain multiple
partitions?
Is the external storage
device write-protected?
Is the USB device's file
system FAT16 or FAT32?
Remedy
• Plug the power cord securely into the power outlet (page 23).
• Unplug the power cord, wait several seconds, then plug the
power cord back in.
If Auto Power Off is set to 15 min or 30 min, the player's power
automatically turns off if no operation is performed for the set
amount of time (page 44).
The player's power may turn off together with the power of
the TV connected to the HDMI OUT terminal. If you do not want
the player's power to turn off when the TV's power is turned
off, set Control to Off (page 42).
The player's power may turn on together with the power of the
TV connected to the HDMI OUT terminal. If you do not want the
player's power to turn on when the TV's power is turned on, set
Control to Off (page 42).
• Use within the specified usage temperature range (page 62).
• If the power cannot be turned off (to standby), reset the unit.
Press and hold the ^ STANDBY/ON button for approx. five
seconds. When the button indicator turns off, release your
finger.The unit restarts and can now be operated.
Operate from within 7 m (23 ft.) of the remote control sensor.
Replace the batteries (page 6).
Depending on the usage environment, the temperature of the
unit's cabinet may increase somewhat during use, but this is
not a malfunction and there is no need to worry.
The input of the TV and AV system (AV receiver or amplifier, etc.)
connected to the HDMI OUT terminal may automatically switch to
the player when playback starts on the player or the menu screen
(Source function, etc.) is displayed. If you do not want the inputs
of the connected TV and AV system (AV receiver or amplifier,
etc.) to switch automatically, set Control to Off (page 42).
Always press ^ STANDBY/ON on the player's front panel or
^ STANDBY/ON on the remote control and check that POWER
OFF has turned off from the player's front panel display before
disconnecting the power cord. Be particularly careful when the
power cord is connected to the AC outlet on another device
because the player turns off in conjunction with the device.
• Turn the player's power off, then turn the power back on.
• Turn the player's power off, then reconnect the external
storage device (page 22).
Do not use an extension cable. The player may not work
properly with it.
External storage device may not work if connected to the USB
port via a memory card reader or USB hub.
External storage devices may not be recognized if they
contain multiple partitions.
Turn the player's power off, then disable the write-protection.
USB devices formatted in the FAT16 or FAT32 file system can
be used.
Some external storage devices may not operate.