Connecting An Av Receiver Or Amplifier - Pioneer UDP-LX500 Mode D'emploi

Connecting an AV receiver
02
or amplifier
Connect to an AV receiver or amplifier in order to
enjoy the surround sound of Dolby TrueHD, Dolby
Digital Plus, Dolby Digital, DTS-HD Master Audio,
DTS-HD High Resolution Audio, DTS Digital
Surround, LPCM, AAC or DSD. For instructions on
connecting the TV and speakers to the AV receiver
or amplifier, refer to the operating instructions for
AV receiver or amplifier.
Caution
• Hold the plug when connecting and
disconnecting the cable.
• Placing a load on the plug could result in faulty
contact and no video signals being output.
Connect a TV to the AV receiver or amplifier, not
to the HDMI OUT (SUB) terminal.
UDP-LX500's rear panel
Match the
direction of the
plug to the
terminal and
insert straight.
AV receiver
or amplifier
HDMI cable
(commerciall
y available)
TV
20
En
To HDMI input
terminal
Direction of signal flow
Achieving better video and sound quality
When connecting one TV (or projector) and AV
amplifier to the player, connect in such a way that
the video and audio signals are transferred
separately in order to achieve higher quality video
and sound.
UDP-LX500's rear panel
HDMI cable
(commercially
available)
TV
Direction of signal flow
Caution
• Make sure to set HDMI Mode to Separate
(page 42).
Match the
direction of the
plug to the
terminal and
insert straight.
AV receiver
or amplifier