Publicité
Les langues disponibles
Les langues disponibles
when fi lling with water or topping up, and
also while the appliance is heating up.
With the steam control open, hot water
may be emitted through the soleplate.
Filling with water
Fill the water reservoir before using the
steam function or the spray nozzle.
Remove the plug from the wall socket and
close the steam control before fi lling the
reservoir.
∙ This steam iron is to a large extent
resistant to hard water (up to 15º dH).
Although normal tap water may be
used, it is advisable to use distilled,
demineralised or decalcifi ed water.
Should you be unsure about the hardness
of the water in your area, please enquire
of the relevant local authority department.
∙ Fill the empty water reservoir using the
measuring cup provided. Fill the reservoir
to the indicated 'Max' level only.
General information about ironing
Always check fi rst whether a label with
ironing instructions is attached to the article
to be ironed.
∙ The meaning of the ironing symbols is as
follows:
•
synthetics
(low temperature)
••
silk and wool
(medium temperature)
••• cotton and linen
(high temperature)
∙ These markings can also be found on the
temperature control knob of the steam
iron in form of dot symbols.
∙ Laundry to be ironed should be
sorted according to the fabric ironing
temperature. Follow the ironing symbols
and start with the lowest temperature.
∙ When ironing highly sensitive fabrics, or
if you are not sure about the fabrics, you
may carefully test-iron at a non-visible
point, e.g. inside of seam. Start with the
lowest temperature.
∙ If the laundry is being dried in a dryer
before ironing, the temperature should be
adjusted to "iron dry". Very dry fabrics are
diffi cult to iron.
Start up
Clean the steam iron before using for the
fi rst time, according to the instructions
given in the paragraph "General Care and
Cleaning". This will result in the removal of
possible dust particles from the soleplate
and subsequently lessen the smell typically
encountered when fi rst switching on.
Please ensure suffi cient ventilation.
Ironing
∙ Steam ironing requires high temperatures.
The temperature level for steam ironing
is indicated on the temperature control
knob.
∙ After fi lling the reservoir with water, place
the steam iron upright on its base stand
and insert the plug into the wall socket.
∙ Set the temperature control knob to the
required ironing temperature as indicated
by the ironing symbols.
∙ During the heating-up process the
indicator lamp will be on. The lamp will go
out once the required ironing temperature
is reached.
∙ Before ironing any fabrics, the soleplate
should be cleaned by passing it over an
old, clean cotton cloth, while using the
steam jet function; this helps to fl ush out
any dirt residues or lint particles trapped
11
Publicité
