Anslut 417049+ Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
Installing internal antifreeze
protection
When the heating cable is connected it
always produces some effect, and this
always increases the temperature of the
water. Internal routing produces much
more of an effect than external routing.
The operating temperature, and therefore
the water temperature, varies depending
on the routing, insulation thickness and
ambient temperature.
For permanent use, and especially for
longer lengths, the cable should be
controlled via a thermostat.
For installation in a water pipe you need a
suitable watertight grommet. The
grommet is fitted on the heating cable.
The junction should be outside the water
pipe.
Installation in water pipe
1.
Fit a T-coupling on the water pipe.
2.
Fit the supplementary unit.
3.
Push in the heating cable and screw tight.
4.
The product consists of a self-limiting
heating cable primarily intended for
antifreeze protection of water and drain
pipes.
EN
11

Publicité

Table des Matières
loading

Produits Connexes pour Anslut 417049+

Table des Matières