Maintenance & Storage - Haussmann PNT240-AG Mode D'emploi

SETUP & OPERATION
5. If a filter-regulator-lubricator is not installed, place up to 6 drops of compressor oil
into the NPT inlet plug before each use.
6. If a filter-regulator-lubricator is installed, keep the air filter clean. A dirty filter will
reduce the air pressure to the tool, which will cause a reduction in power,
efficiency, and general performance.
7. For optimal performance, install a quick connector to the tool and a quick coupler
on the hose, if applicable.
8. Verify that all of the connections in the air supply system are sealed in order to
prevent air from leaking.
OPERATING THE AIR MINI DIE GRINDER
WARNING: Read all instructions in this manual carefully and understand them
thoroughly before using the die grinder.
1. Connect the tool to the air hose.
2. Depress the trigger in order to operate the tool.
3. Verify that the air supply is clean, and that it does not exceed 90 PSI while
operating the tool. If the air pressure is too high or air is unclean, it will shorten the
life of the tool, and may be dangerous.
4. The air flow can be regulated by adjusting the flow valve at the base of the
handle.
Do not apply additional or excessive force to the tool when grinding.
Do not allow the die grinder to run free for an extended period of time. Doing so will
shorten the life of the die grinder.
MAINTENANCE & STORAGE
MAINTENANCE
WARNING: Disconnect the die grinder from the air supply before changing
accessories, servicing, or performing maintenance. Replace or repair damaged parts
before using the die grinder. Use only recommended replacement parts. The use of
non-authorized parts may pose a danger.
1. Lubricate the air mini die grinder daily by dripping a few drops of air tool oil into
the air inlet.
2. Do not use worn or damaged accessories.
3. A loss of power or erratic action may be due to the following:
a) Excessive drain on the air line; moisture or restriction in the air pipe; incorrect
size or type of hose connectors. To remedy these situations, verify the air supply
and follow instructions.
b) Grit or gum deposits in the air-powered mini die grinder may also reduce
performance. If the air-powered mini die grinder has an air strainer (located in the
area of the air inlet), remove the strainer and clean it.
4. When the air mini die grinder is not in use, disconnect it from the air supply, clean
it, and store it in a safe, dry, and childproof location.
STORAGE
If it is necessary to store the tool for an extended period of time, apply a generous
amount of lubrication before storing. The tool should be run for approximately 30
seconds in order to ensure that the lubrication is evenly distributed throughout the tool.
The tool should be stored in a clean and dry environment.
18
PNT240-AG
!
!