Air Supply And Connections; Additional Safety Instructions For Mini Die Grinder - Haussmann PNT240-AG Mode D'emploi

ADDITIONAL SAFETY INSTRUCTIONS FOR MINI DIE GRINDER

!
!
GENERAL SAFETY INSTRUCTIONS
SERVICE
Tool service must be performed only by qualified repair personnel.

When servicing a tool, use only identical replacement parts. Use only authorized

parts.
Use only the lubricants supplied with the tool and specified by the manufacturer.


AIR SUPPLY AND CONNECTIONS

The air supply connection must not hold pressure when air supply is disconnected.

If an incorrect fitting is used, the tool can remain charged with air after
disconnecting and thus will be able to work even after the air line is disconnected,
possibly causing injury.
Do not use any type of reactive gases, including, but not limited to, oxygen and

combustible gases, as a power source. Use filtered, lubricated, regulated
compressed air only. Use of a reactive gas instead of compressed air may cause
the tool to explode which will cause death or serious personal injury.
Use only a pressure-regulated compressed air source to limit the air pressure

supplied to the tool. The regulated pressure must not exceed 100 PSI. If the
regulator fails, the pressure delivered to the tool must not exceed 200 PSI. The
tool could explode which will cause death or serious personal injury.
Always disconnect air supply from tool:

a) before making adjustments.
b) when servicing the tool.
c) when clearing a jam.
d) when tool is not in use.
e) when moving to a different work area, as accidental actuation may occur,
causing injury.
Inspect the air-powered die grinder prior to each use in order to:

a) ensure that the proper power source is being used;
b) verify that the tool is in proper working order.
Do not use a tool that is not in proper working order.

Do not use oxygen or any other combustible or bottled gas to power this tool.

Do not use this tool in the presence of flammable liquids or gases.

Only use accessories that are specifically designed for use with this tool.

Drain the air tank daily. Water in the air line will damage the die grinder.

Clean the air inlet filter weekly.

The pressure in the line should be increased in order to compensate for an

unusually long air hose (longer than 26' [8 m]). The diameter of the hose should
be 3/8" (10 mm) ID.
Keep the hose away from heat, oil, and sharp edges. Check the hose for wear,

and verify that all connections are secure.
WARNING! Always verify that the grinding area is clear of any flammable materials,
liquids, or gases, because the use of this tool creates sparks when grinding a wide
variety of materials!
Verify that the die grinder is switched off before connecting it to the air supply.

Disconnect the die grinder from the air supply before changing attachments, and

before performing any type of servicing.
WARNING! Verify that grinding accessories that are used with this tool are rated at or
above the tool's speed rating (20,000 RPM). Failure to properly match the accessory
to the tool could result in serious personal injury.
15