Specifications - Haussmann PNT240-AG Mode D'emploi

ADDITIONAL SAFETY INSTRUCTIONS FOR MINI DIE GRINDER
Keep air-powered tools clean and lubricated. Daily lubrication is essential in order

to avoid internal corrosion and possible failure.
Using only lightweight coil hoses from the tool to the wall or to the compressor

coupling.
Do not overload the tool. For maximum efficiency, allow the tool to operate at its

optimum speed.
Do not increase the air pressure above the manufacturer's recommended level.

Doing so will cause excessive wear on moving parts, and possible failure.
In the interests of safety and in order to avoid possible damage to the tool and

injury to the operator, verify that the tool has come to a complete stop before
putting it down after use.
Verify that the workpiece is secure in order to free both hands to control the die

grinder.
Verify that accessories, such as discs, are rated/designed for use with this die

grinder. Verify that they are correctly and securely fastened before connecting the
tool to the air supply.
When grinding, always wear an appropriate face mask and/or respiratory

equipment.
Do not direct air from the air hose at the operator or at others.

When the die grinder is not in use, disconnect it from the air supply, and store in a

safe, dry, childproof location.

SPECIFICATIONS

This HAUSSMANN air-powered mini die grinder is ideal for light weld breaking,
grinding, porting and polishing applications, and for smoothing sharp edges. The
throttle-lever features a "lock-off" mechanism for added safety. The durable, lightweight
composite housing design helps to reduce vibration. Exhaust is discharged through the
rear of the grinder.
Grinder capacity: 1/4" (6 mm)

No-load Speed: 20,000 RPM

Average Air Consumption: 4 CFM (115 L/min)

Operating Pressure: 90 PSI

Air Inlet Size: 1/4" (6 mm) NPT

Air Hose: 3/8" (10 mm) ID

ACCESSORIES
Wrenches

1/4" NPT male connector

Grinding stones

16
PNT240-AG
2
1
5