B
A
C
Quick
Connector
Tool
Quick Coupler
FUNCTIONAL DESCRIPTION
Figure 1 names the major components of the HAUSSMANN
air-powered mini die grinder:
A. Trigger
B. Lock-off switch
C. Grinding collet/Chuck
D
D. Air Inlet
Fig.1
SETUP & OPERATION
BEFORE YOU START
Compatible Compressor & Air Tool - Guidelines for Proper Usage & Operation
Always ensure the use of appropriately matched air tools and compressors. Be sure
that the air compressor being used can supply the appropriate volume, pressure and
delivery rate of air to the tool(s) without running continuously. Using tools or
combinations of tools that together or separately require more than the air
compressor can deliver will reduce performance and could void the compressor or tool
warranty.
AIR SYSTEM (Fig.2)
Quick
Connector
Air Hose
1.
Always use clean, dry, regulated compressed air at 60 to 100 PSI.
2.
Do not exceed the maximum and minimum pressures. Operating the tool at the
wrong pressure (too low or too high) will cause excessive noise or rapid wear.
3.
Keep hands and other parts of the body away from the tool's discharge and
working areas when connecting the air supply.
4.
It is recommended that a filter-regulator-lubricator be used, and that it be located
as close to the tool as possible.
Filter
Lubricator
Quick
Coupler
Regulator
Air
Compressor
Cut-off
valve
Fig.2
17