Fitting Instructions - Brink 2370 Mode D'emploi

GB
Couplings class
Approval number
D- Value
Max. trailers dimensions
Max. vertical load

FITTING INSTRUCTIONS:

1. Remove the rear lights from the bumper. Place the tow bar with holes A
on the threaded holes on the underside of the chassis. Screw four M12
x 1.25 x40 bolts with spring and plain washers finger tight.
2. Fit two M12 x 130 bolts with spring and plain washers and nuts at points
B. The ball hook is fitted to the tow bar with two M12 x 70 bolts, plain
washers and self-locking nuts. Tighten the bolts at points A to a maxi-
mum torque of 69 Nm. (Manufacturer's Specification). Tighten all remai-
ning bolts and nuts to the torque given in the table. Replace the rear
lights.
* Attention: A vertical load of 100 kg applies to models from before 07-
'97. For models from 07-'97 and after, the vertical load is 135 kg.
: A 50-X
: e11 00-0313
: 15,0 kN
: 3300 kg
: *135 kg
NOTE:
* Remove the insulating material from the contact area of the fitting points.
* All bolts are quality 8.8 - nuts 8. or when mentioned in fitting instructions
10.9 / 10.
* Don't forget the spring- and plain washers.
* Consult your dealer for the maximum tolerated pull weight and ball
hitch pressure of your vehicle.
* It is recommendable to retighten all fixing bolts and nuts after the towbar
has been in use for some 1000 km/600 miles.
* Do not drill through brake-or fuellines.
* Remove (if present) the plastic caps from the spot welding nuts.
Torque settings for nuts and bolts (8.8):
M12 79 Nm
M12x1.25 69 Nm
71 Nm (with self-locking nut)
© 2370/20-03-2013/3