ETQ TG32P12 Manuel Du Propriétaire page 8

ETQ
EASTERN TOOLS & EQUIPMENT INC
Attach Wheels
To attach the wheels to the generator, perform the following steps:
1. Take one wheel shaft and one M12 nut as shown. Slide the wheel shaft, with the threaded part
facing inward, through the frame holes. Secure using an M12 nut and the included wrench as
shown in figure 4.
2. Lift up slightly the generator frame and put shaft into the holes of wheel and tighten it on the frame
and Slide the wheel onto the axle and secure in place using a large cotter pin as shown in figure 5.
3. Place one washer on the shaft and do not obstruct the hole of the shaft. Spread the pin legs apart
slightly to help secure the pin in place.
4. Repeat steps 2 and 3 for the other wheel.
Figure 3 - Placing the shaft
Tel: (888)908-6200
Figure 5 - Wheel installation
7
Web Site: easterntools.com
Figure 4 - Shaft assembly