Assembly - ETQ TG32P12 Manuel Du Propriétaire

ETQ
EASTERN TOOLS & EQUIPMENT INC
In order to best protect the generator while in the package, this product comes with some components
disassembled. Please complete the following assembly steps before proceeding to use the generator.
For ease of assembly, we recommend attaching the components in the order listed in this manual.
If after reading this section, you are unsure about how to perform any of the steps,
please call (888)908-6200 for customer service.
WARNING: This generator is heavy. Some assembly procedures may require
two people.
Attach Feet
To attach the feet to the generator, perform the following steps:
1. Stack the two generator wheels on top of each other. Lift the end of the generator that has the
recoil starter onto the stack of wheels (see figure 1). Be careful not to obstruct any holes on the
generator.
2. Place one foot onto the frame as shown in figure 2. Line up the holes on the generator frame with
the holes on the bracket portion of the foot. Tighten the M6x40 bolts and M6 nuts, using the
included wrench.
3. Repeat step 2 for the other generator foot.

ASSEMBLY

Figure 1 - Stacking the wheels
A
Figure 2- Foot assembly
Tel: (888)908-6200
6
Web Site: easterntools.com
B