ETQ TG32P12 Manuel Du Propriétaire page 34

ETQ
EASTERN TOOLS & EQUIPMENT INC
Normal wear:
Engines and generators, like all mechanical devices, need periodic parts service and replacement to perform well.
Warranty will not cover repair when normal use has exhausted the life of a part of an engine.
Improper maintenance:
The life of an engine or your equipment depends upon the conditions under which it operates, and the care it receives.
Some applications, such as tillers, pumps, and rotary movers, are very often used in dusty or dirty conditions, which can
cause what appears to be premature, wear. Such wear, when caused by dirt, dust, spark pug cleaning grit, or other
abrasive material that has entered the engine because of improper maintenance is not covered by warranty.
This warranty cover engine related defective material and/or workmanship only, and not replacement or refund of
the equipment to which the engine may be mounted. Nor des the warranty extend to repairs required because of:
1. Problems caused by parts that are not original eastern tools & equipment, inc., parts.
2. Equipment controls or installations that prevent starting, cause unsatisfactory engine performance, or shorten
engine life. (Contact equipment manufacturer.)
3. Leaking carburetor, clogged fuel pipes, sticking valves, or other damage, caused by using contaminated or stale
fuel. (Use clean, fresh, lead-free gasoline.)
4. Parts which are scored or broken because an engine was operated with insufficient or contaminated lubricating
oil, or and incorrect grad of lubricating oil (check oil level daily or after every 8 hours of operation. Refill when
necessary and change at recommended intervals.) Engine damage may occur if oil level is not properly
maintained. Read Operating & Maintenance Instructions.
5. Repair or adjustment of associated parts or assemblies such as clutches, transmissions, remote controls, etc.,
which are not manufactured by Eastern Tools & Equipment, Inc.
6. Damage or wear to parts caused by dirt, which entered the engine because of improper air filter maintenance,
re-assembly, or use of a non-original air filter element or cartridge. Read Operating & Maintenance Instructions.
7. Parts damaged by over-speeding, or overheating caused by grass, debris, or dirt, which plugs or clogs the
cooling fins, or flywheel are, or damaged caused by operating the engine in a confined area without sufficient
ventilation.
8. Engine or equipment parts broken by excessive vibration caused by a loosen cutter blades unbalanced blades or
loose unbalanced impellers, improper attachment of equipment to engine crankshaft, over speeding or other
abuse in operation.
9. A bent or broken crankshaft, caused by striking a solid object with the cutter blade of a rotary lawn mower, or
excessive v-belt tightness.
10. Routine tune-up or adjustment of the engine.
11. Engine or engine component failure, i.e., combustion chamber, valves, valve seats, valve guides, or burned
starter motor winding, caused by the alternated fuels such as, liquefied petroleum, natural gas, altered gasoline's
etc.
Warranty is available only through service dealers, which have been authorized by Eastern Tools & Equipment,
Inc., please contact the place of purchase or Eastern Tools & Equipment, Inc. for a Service Dealer near you.
CALIFORNIA & US EPA EMISSION CONTROL WARRANTY STATEMENT
The U.S. Environmental Protection Agency (EPA), the California Air Resources Board (CARB) and Eastern Tools &
Equipment, Inc. are pleased to explain the Federal and California Emission Control System Warranty on your small
nonroad engine. In California, new small nonroad engines must be designed, built and equipped to meet the State's
Tele: (888)908-6200
33
Web Site: easterntools.com