Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. TROUBLESHOOTING
You cannot activate the
appliance or operate it.
An acoustic signal
sounds and the appliance
deactivates.
An acoustic signal
sounds when the appli-
ance is deactivated.
The appliance deacti-
vates.
The residual heat indica-
tor does not come on.
The Automatic Heat Up
function does not oper-
ate.
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no signal when
you touch the panel sen-
sor fields.
comes on
comes on
Problem
Possible cause
You touched 2 or more
sensor fields at the same
time.
The STOP+GO function
operates.
There is water or fat
stains on the control pan-
el.
You put something on
one or more sensor fields.
You put something on the
sensor field
.
The cooking zone is not
hot because it operated
only for a short time.
The cooking zone is hot.
The highest heat setting
is set.
The Power management
is activated.
The cookware is too large
or you put it too near to
the controls.
The signals are deactiva-
ted.
The Automatic Switch Off
operates.
The Child Safety Device
or the Lock function op-
erates.
ENGLISH
Remedy
Activate the appliance
again and set the heat
setting in less than 10
seconds.
Touch only one sensor
field.
Refer to the chapter "Dai-
ly Use".
Clean the control panel.
Remove the object from
the sensor fields.
Remove the object from
the sensor field.
If the cooking zone oper-
ated sufficiently long to
be hot, speak to the serv-
ice centre.
Let the cooking zone be-
come sufficiently cool.
The highest heat setting
has the same power as
the Automatic Heat Up
function.
Refer to "Power manage-
ment".
Put large cookware on
the rear cooking zones if
necessary.
Activate the signals (refer
to "OffSound control").
Deactivate the appliance
and activate it again.
Refer to the chapter "Dai-
ly Use".
13
Publicité
Chapitres
Table des Matières
