JVC TK-C205 Mode D'emploi page 14

Installation and connection
Mounting the Camera to the Ceiling (continued)
2.
Video signal
cable
Safety
cable
3.
4.
Wrap with
tape
BNC
connector
E-12
Attach to ceiling slab
1.
Solder or
crimp
Insulation
tape
Power supply cable
Power
supply
cable
connection
Wrap with
tape
Installation
1.
Connect the power supply cable.
Connect the cable protruding from the
ceiling to the power supply cable.
MEMO
The power supply cable uses materials
similar to those of machinery wiring, so
wrap the cable with insulation tape to
prevent it from becoming damaged when
mounting the camera.
Use durable wiring for the power supply
cable.
2.
Attach the safety cable to the ceiling
slab. (Safety cable not included)
Attach the safety cable that has already
been attached to the camera to the
ceiling slab or channel.
Make sure that the wire is attached
securely.
3.
Connect the video signal cable.
4.
Wrap insulation tape around cables.
As shown in the diagram to the left,
wrap insulation tape around the power
supply cable connection and BNC
connector. Insert the cables into the
hole in the ceiling.
MEMO
Wrapping the wires with insulation tape
improves handling as well as reducing
interference.