Noise/Vibration Information; Declaration Of Conformity; Auxiliary Handle - Bosch PSB 700 RE Mode D'emploi

16 | English

Noise/Vibration Information

Measured values determined according to
EN 60745.
Typically the A-weighted noise levels of the prod-
uct are: Sound pressure level 100 dB(A); Sound
power level 111 dB(A). Uncertainty K = 3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Drilling into metal: Vibration emission value
2
a = 4.5 m/s , Uncertainty K = 1.5 m/s
h
Impact drilling into concrete: Vibration emission
2
value a = 36 m/s , Uncertainty K =4.5 m/s
h
Screwdriving: Vibration emission value
2
a < 2.5 m/s , Uncertainty K = 1.5 m/s
h
The vibration emission level given in this informa-
tion sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another. It
may be used for a preliminary assessment of ex-
posure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with differ-
ent accessories or poorly maintained, the vibra-
tion emission may differ. This may significantly
increase the exposure level over the total work-
ing period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
1 609 929 M94 | (16.10.07)
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
05.09.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
2
,
2
,
Assembly
2
.
Before any work on the machine itself, pull
the mains plug.

Auxiliary Handle

Operate your machine only with the auxiliary
handle 10.
The auxiliary handle 10 can be set to any position
for a secure and low-fatigue working posture.
Turn the wing bolt for adjustment of the auxiliary
handle 9 in anticlockwise direction and set the
auxiliary handle 10 to the required position. Then
tighten the wing bolt 9 again in clockwise direc-
tion.
Adjusting the Drilling Depth
The required drilling depth X can be set with the
depth stop 11.
Press the button for the depth stop adjustment 8
and insert the depth stop into the auxiliary han-
dle 10.
Pull out the depth stop until the distance be-
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drilling
depth X.
The knurled surface of the depth stop 11 must
face upward.
Dr. Eckerhard Strötgen
Head of Product
Certification
Bosch Power Tools