Using Your Electronic Control; Starting Your Beverage Center; Turning Your Beverage Center On Or Off; Set The Temperature - AGA marvel ML24BCG0 Instructions D'installation, D'utilisation Et D'entretien

Alarm
Figure 10
close-up of
control
Set
Press and Hold

Starting your beverage center

Plug the beverage center power cord into a wall outlet. Your
beverage center will begin cooling after power is applied.
If your beverage center does not start, check that the bev-
erage center is turned on and the set temperature is cold
enough.

Turning your beverage center ON or OFF

If the beverage center is on, the beverage center tempera-
ture will be shown on the display. To turn the beverage
center off, press and hold the "ON/OFF" button for three (3)
seconds. "OFF" will appear on the display.
If the beverage center is not on, "OFF" will be shown on
the display. To turn the beverage center on, press and hold
the "ON/OFF" button for three (3) seconds. The beverage
center temperature will be shown on the display.
Set temperature
To set the beverage center temperature, press and hold
the "SET" button. When the "SET" button is pressed, the
display will show the set temperature. While holding the
"SET" button, press the "WARMER" or "COLDER" buttons
to adjust set temperature.

Beverage center operation

The available temperature range of the beverage center is
34° to 42°F (1° to 6° C).
It may take up to 24 hours for your beverage center to
reach desired temperature. This will depend on amount of
content loaded and number of door opening and closings.
For best results allow beverage center to "pull down" to
desired set temperature before loading. Once contents are
loaded, allow at least 48 hours for temperature to stabilize
before making any adjustments to the set temperature.

Alarms

Your MARVEL Prime Controls™ will monitor beverage
center function and alert you with a series of audible and
visual alarms.
• Door Ajar Alarm: If the door has been left
open for over five (5) minutes, the alarm
will sound in one (1) second intervals. The
display panel will flash "do" and the Alarm LED located at
the top left of the display below the word "Alarm" will be il-
luminated. This will stop as soon as the door is closed.

USING YOUR ELECTRONIC CONTROL

F
Colder Warmer ON/OFF
Press and Hold
Control
Light Switch
• Temperature Sensor Fault: If the control-
ler detects that the temperature sensor is
not properly functioning, a temperature
sensor alarm will sound in one (1) second intervals. "E1"
will flash on the display panel and the Alarm LED located
at the top left of the display below the word "Alarm" will be
illuminated. Please call AGA MARVEL Customer Service or
your dealer if this error code is displayed.
• High and Low Temperature Alarm: If the
storage compartment temperature deviates
excessively from the set-point temperature, the
alarm will sound in (1) second intervals. The
display panel will flash either "Hi" or "Lo" de-
pending upon the condition and the Alarm LED
light at the top left of the display below the word
"Alarm" will be illuminated. The alarm will remain active
until the condition is corrected.
NOTE
After a high temperature alarm condition, check all perish-
ables to ensure they are safe for consumption.
NOTE
The temperature alarm may occur as a result of high usage
or introduction of warm contents to the storage compart-
ment. If the temperature alarm continues to occur, your unit
may require service.

Alarm Mute

Press any key to mute the audible portion of an alarm.
NOTE
This action will only mute the alarm. If the condition that
caused the alarm continues, the alarm code will continue to
flash and will sound for 20 seconds every 60 minutes.
8
Figure 11
Control
Assembly
Door Switch