Operating Instructions; Overview; Charging The Power Pack; Charging Using The Plug Charger - EUFAB 16643 Manuel De L'opérateur

6. OPERATING INSTRUCTIONS

6.1 OVERVIEW

Image 1: Front view Image 1: Front view
Image 2: Rear view
Image 4: Accessories
1 Charging socket
2 Charging indicator light
3 LED working light
4 Black pole calliper (-)
5 Red pole calliper (+)
6 Charge status display
7 Switch for LED working light
8 Push button for charge status display
9 Manometer
10 ON/OFF switch for compressor
11 Storage compartment cover for air hose
12 12 V socket
13 Plug charger
14 Motor vehicle charging cable
15 Valve adapter
Image 3: View right

6.2 CHARGING THE POWER PACK

Charge the Power Pack fully after purchase or before using
for the fi rst time. Leave the Power Pack connected to the
charger for a maximum of 48 hours.
To check the charge status, fi rst remove the charging cable,
then press the control button for the charge status (position
8 in the overview). If the voltmeter for the charge status
(Position 6 in the overview) shows a value of 50% or less,
yellow section (Figure 5), then the Power Pack must be
charged. If the value is over 50%, green section (Figure 6),
the Power Pack is ready for use.
Image 5: Battery must be
charged

6.2.1 CHARGING USING THE PLUG CHARGER

Switch off the compressor and the working light. Remove
all consumers connected to the Power Pack. Plug the coaxial
connector of the plug charger (Position 13 in the overview)
into the charging socket of the Power Pack (Position 1 in the
overview). Now, connect the plug charger with the mains
socket. The charge control lamp (Position 2 in the overview)
now lights up. If the battery is completely empty, the
charging process will take max. 48 hours. After charging,
fi rst disconnect the plug charger from the mains socket,
then disconnect the coaxial connector from the charging
socket of the Power Pack. If you now press the push button
for the charge status (Position 8 in the overview), the
Voltmeter shows a voltage of approximately 13 V for the
charge status (Position 6 in the overview).
Do not leave the plug charger connected
for longer than 48 hours!

6.2.2 CHARGING USING THE 12 V MOTOR

VEHICLE CHARGING CABLE

Switch off the compressor and the working light. Remove
all consumers connected to the Power Pack. Plug the coaxial
connector of the 12 V motor vehicle charging cable (Position
14 in the overview) into the charging socket of the Power
Pack (Position 2 in the overview). Now connect the 12 V
plug to the 12 V socket of your vehicle. The charge control
lamp (Position 1 in the overview) now lights up. If the
battery is completely empty, the charging process will take
approximately 17 hours. After charging, fi rst disconnect
the 12 V plug from the 12 V socket of your vehicle and then
Figure 6: Battery is fully
charged
9