Functions And Operation; Control Panel - glass 1989 STEAM PLUS Notice D'installation

FUNCTIONS AND OPERATION

1. CONTROL PANEL:

PANEL to activate it.
AROMA PUMP (6), FAN (7), COLOURED
LIGHTS (8) and ON / OFF (4) is accessed to the individual
functions.
Through the SET (3), (2) and
the various parameters of individual functions.
To change parameters of the functions, press the SET button
(3) until it lights the symbol of the function you want to edit, then
(2) and
Your changes are stored after 5 "without touching a button.
NOTE: also appear in the display icons of the "optional
functions" even if they are not purchased with the product.
ON / OFF button Steam
function and lights on the display icon (S4)
NOTE: The display lights up the (S4)
in conjunction with "Fast steam" button (optional) previously
preset.
Lighted symbol:
• (S9)_Temperature instructions: shows the steam room
temperature value. Set the temperature at SET (3). Room
temperature lower than 6°C, all-in-one screen shows "-L".
Room temperature lower than 60°C, all-in-one screen
shows "-H". Under "-L" or "-H", the heating elements will
• (S11)_Working time: timing function, the default value
"CH"(non stop).
• (S13)_Heat preservation instructions: shows the room
temperature reaches 2°C higher than your setting value,
under heat preservation state.
• (S15)_Water inlet valve:
• (S16)_High water level: shows the water level in water
• (S17)_Middle water level: shows the water level in water
• (S18)_Low water level: shows the water level in water
• (S19)_Water tank temperature:
temperature, if it is over 115°C steam generator go into
protection state, controller screen shows "OH", steam
generator stop heating. When the temperature lower than
please contact the dealer for maintenance).
COLOURED LIGHTS button "chromotherapy" (Optional)
Coloured lights could be set to "Color changeless" or "Colors
cycle", default "Colors changeless".
(S2)
mode of "Manual selection" color (light spotlights).
By pressing the buttons (2) and (5) will change color manually.
To set the "Automatic color cycle" mode (S2-1) press the SET
(5) you select and you adjust
(5) you can change the parameter.
(4)
"domentic".
"commercial" only
OH" comes,
(8), the icon will light
button (3) until you see the icon (S2) + (S2-2)
and (5) select the Auto icon color mode (S2-1) on. The function
is stored after 5" without touching a button.
To activate the "automatic color cycle", press the button (8).
FAN button (Optional)
Switch On or OFF the FAN. The display shows the operating
time.
The time can be set from 1 ~ 60 minutes by changing parameters
of the function (S1).
AROMA PUMP button - "aromatherapy" (Optional)
time).
Lighted symbol (S8), indicate aroma pump is on.
(3).
NOTE:
on.
DESCALING (Optional):
(S14)_Lighted symbol: symbol is active if steam generator
Descaling time is from 0~8 hours.
1A. FAST STEAM (Optional)
Commercial model:
temperature at 80°C, once the customer go into the steam
room, press in the "FAST STEAM" controller, the steam will
"Commercial model": steam generator is under commercial
power supply, then switch the bottom).
COMMERCIAL MODEL
change-over switch (
"Domestic model": steam generator is under domestic model.
power supply, then switch the bottom).
31
)
EN
(2)