glass 1989 STEAM PLUS Notice D'installation page 23

SAFETY VALVE
AUTO DRAIN VALVE
WATER MAGNETIZER
copper pipe to connect the safety valve and the drain pipeline
of the house.
The drain pipeline should be installed with small angle so as to
5. ELECTRICAL INSTALLATION
Caution:
• All circuits should be installed by licensed electricians and
conform to local and national codes.
•
generator cannot cut power from the supply.
• No additional power supply or wire is allowed to connect
to the generator. Do not connect the ground wire to the
neutral wire.
• Only the original parts and elements from our factory are
allowed to be used in installation, operation, maintenance
and repair.
• After the installation of the pipeline and electrical circuits,
generator.
•
tested in factory, thus user only need to install the power
wire and control wire.
INSTALLATION OF POWER WIRE
See the technical sheet of the product, www.glass1989.it
Caution:
• The power supply should be 220-240V or 380-415V,
•
sheet of the product).
• Choose the suitable power wire (see the technical sheet of
generator, insert the 3-core power wire (single phase, 220-
2-6).
Single phase, 220-240V, 50/60Hz power supply:
connect the live wire to the terminal labeled as "L" ; connect
the neutral wire to the terminal labeled as "N" ; and connect the
ground wire to the terminal labeled as "
Three phases, 380-415V,50/60Hz power supply:
connect the L1, L2, L3 wire to the terminal labeled as "L1", "L2"
and "L3" respectively; connect the neutral wire to the terminal
labeled as "N"; and connect the ground wire to the terminal
labeled as " ".
American 2 phase,220-240V,50/60Hz power supply:
connect the L1,L2 wire to the terminal labeled as "L1","L2"
respectively, connect the ground wire to the terminal labeled
as " ".
23
EN
".