Before First Use - Zanussi ZOB 482 XL Notice D'utilisation

• Cut off the mains cable and discard it.

Before first use

Warning! Refer to the Safety chapters.
Remove all packaging, both inside and
outside the oven, before using the appli-
ance. Do not remove the rating plate.
Caution! To open the oven door, always
hold the handle in the centre.
Setting the time
You must set the time before you operate
the oven.
When you connect the appliance to the electri-
cal supply or after a power cut, the indicator for
the Time function flashes.
Press the + or - button to set the correct time.
www.zanussi.com
• Remove the door catch to prevent children
and pets to get closed in the appliance.
After approximately five seconds, the flashing
stops and the display shows the time of day
you set.
When you change the time, you must not
set the Duration
the same time.
Initial Cleaning
• Remove all parts from the appliance.
• Clean the appliance before first use.
Caution! Do not use abrasive cleaning
agents! This can damage the surface.
Refer to chapter "Care and Cleaning".
Preheating
1. Set function
2. Run an empty oven for 45 minutes.
3. Set function
4. Run an empty oven for 15 minutes.
This is to burn off any residue from the cavity
surface. Accessories can become more hot
than in normal use. During this period an odour
and smoke can be emitted. This is normal.
Make sure the airflow is sufficient.
or End function at
and maximum temperature.
and maximum temperature.
19