Yukon RANGER RT 6.5x42 Mode D'emploi page 6

7
BASIC MENU ICONS
15
Display brightness level
13x
Full magnification (optical+digital)
IR Illuminator power level
Battery charge indicator
Operation on external power supply
Built-in microphone
Wi-Fi
/ Operating modes: video recording / Image capture
/ Video review / Image review
8
OPERATION
Remove the lens cap from the objective lens (8).
Turn the unit on by briefly pressing the
battery charge icon . The short range IR Illuminator switches on automatically.
To turn the display off during operation, press and hold down the
The display will show a DISPLAY OFF
To turn the display on, press br iefly the
To turn the unit off, press and hold down the
"Switch off" , countdown will start from 3 to seconds, and the unit turns off.
5
ON (15) button - the green LED (16) will light up. The display shows the
ON button for more than one second.
message.
ON button.
ON button for more than three second. The display shows message
1
Achieve a crisp image of the icons on the display by rotating the eyepiece diopter adjustment ring
Locate an object within 20 to 30 metres.
Achive a crisp image of the object by rotating the objective lens
Adjust the image brightness by turning the adjustment wheel
are shown in the right top corner of the display. The adjustment range is 0 to 20.
When changing the viewing distance, obtain a sharp and high-quality image by rotating the objective lens
(8) and the wheel (7) . There is no need to rotate the eyepiece - you have already made the necessary
individual adjustment.
To increase the range of detection and identification in low light conditions or in complete darkness, you
may switch on the built-in LED IR Illuminator (10)
illuminator allows you to increase the observation distance and recognise the object.
Press the IR button successively to change power level (from 1 to 3). The corresponding icon
appear in the upper part of the display.
To turn the IR Illuminator off, press and hold down the
disappear.
You can find a detailed description of IR Illuminator operation in section 12 "BUILT-IN IR
ILLUMINATOR".
To activate the digital zoom, briefly press the ZOOM (14)
To start video recording, press briefly the REC (12) button. The LED indicator (16) blinks while recording
is on.
(6)
(8) .
(7) . The brightness level and brightness icon
: remove the cap and press the IR (13) button. The IR
IR button for two seconds. The IR icon will
button.
.
will
6