Usb Connection - Yukon RANGER RT 6.5x42 Mode D'emploi

To switch between IR power levels, successively press the IR button to cycle through the available
options: IR1->IR2->IR3 ->IR1...
To switch off the IR Illuminator, hold down the IR button. The icon is not displayed.
The IR Illuminator power level is not saved.
You cannot control the IR Illuminator when operating the unit in REVIEW mode.
Upon activation of REVIEW mode, the IR Illuminator switches off, the power level is saved, and the
icon is not shown on the display.
Upon exiting REVIEW mode, the IR Illuminator reverts to the power level selected before
deactivation, with the corresponding icon shown on the display.
13
DISPLAY OFF FUNCTION
This function deactivates the display, which allows you to eliminate light exposure caused by the
glowing display.
You can operate the DISPLAY OFF function in two modes: VIDEO and PHOTO.
To turn the display off, press and hold down the ON (15) button for more than a second.
The message DISPLAY OFF appears on the black display.
To activate the display, press and hold down the ON button for more than a second.
When the DISPLAY OFF function is activated:
All controls are inactive (except for the ON button).
Video recording continues (if video was recording before activating the DISPLAY OFF function).
The Wi-Fi function keeps running.
The DISPLAY OFF function deactivates when:
The ON (15) button is briefly pressed.
17
The unit is connected to a PC via the USB port or to an external portable power supply (in this case the
display should activate and the unit switches to operating mode).
14

USB CONNECTION

The unit can be connected to a PC via the USB port (4). The PC will detect the unit automatically, no driver
installation is necessary.
Connection options.
When the activated unit is connected to a PC via the USB port, one of the following connection options is
selected:
USB Mass storage device
If this option is selected, the unit is detected by the PC as a flash card. The unit switches to USB power.
This option is designed for use when working with files saved in the unit's memory. In this mode the unit's
functions are not available and the unit is "off".
Power
When this option is selected, the PC is used by the unit as an external
power supply. The external power icon appears on the display in
place of the battery charge icon .
The unit continues to operate, all functions are available.
Press the navigation buttons to cycle between connection options
(USB-> Power-> USB...).
To confirm the selection, briefly press the ZOOM (14) button.
960p 04:23pm
Active connection Inactive connection
option option
18