Yukon RANGER RT 6.5x42 Mode D'emploi page 14

18
TROUBLESHOOTING
The table below lists some potential problems that may occur when using the scope. If the problem
experienced with the scope is not listed, or if the suggested action does not resolve the problem,
the unit should be returned for repair.
Problem Check
Check that the batteries are correctly
The unit will not turn on.
fitted in the battery compartment.
Check battery operation.
Oxidized contacts in the battery
compartment due to "leaky" batteries
or contacts have been exposed to
a chemically active liquid.
The unit does not Make sure your power supply Is
providing output voltage.
operate on external
power supply.
Poor image quality. Check that the eyepiece and
lens are adjusted in accordance with
the user manual.
Make sure the lenses are not misted or
soiled.
21
Corrective action
Replace the batteries or fit the batteries
correctly.
Clean the battery compartment,
clean the contacts.
Charge the external power supply
(if required).
Check that the USB cable is intact.
Adjust the unit according in
accordance with the user manual.
Clean the lenses with a cloth moistened
with alcohol.
Problem Check
The unit is beyond reliable Wi-Fi range.
No Wi-Fi signal or erratic
signal. There are obstacles between the unit
and the signal receiver (concrete walls
for example).
The unit is not operating Please restore the original software
properly due to software version.
update.
Corrective action
Place the unit in line-of-sight of the Wi-Fi signal.
1) Hold down simultaneously the REC and ZOOM
buttons.
2) Hold down the ON button (while holding REC
and ZOOM).
3) The green LED will blink twice, then will start
blink constantly:
the original software is being installed.
4) Release REC and ZOOM.
5) Once software installation is over, the LED is
blinking with a 1 sec interval.
6) Disconnect the unit from the power supply
(remove the batteries or disconnect an external
power supply).
22