Installation Of Electric Pre-Heater Kwl-Evh - Helios KWL EC 200 W ET R Notice De Montage Et D'utilisation

Installation and Operating Instructions
+
TIP
+
IMPORTANT
Compact wall-mounted units KWL EC 200/300 W ET R/L
2 .3 Installation of electric pre-heater KWL-EVH . . . W (accessories)
Preparation: Open and remove both upper snap-in hooks on the front cover.
It is recommended that the enthalpy heat exchanger is removed for improved freedom of movement
(note section 3 .1)!
1. Screw the electric pre-heater KWL-EVH ... W (accessories) to the provided mounting bracket (Fig.16/17).
Mounting bracket
for electric
pre-heater
2. Clip the connector on the electric pre-heater to the pre-installed unit plug (Fig.18).
3 . These must be secured to the sheet metal wall for the smooth connection of the electric cable .
4. Adhere enclosed adhesive socket to the sheet metal wall (Fig.20)
5. Clamp the electric cable to the sheet metal wall with the enclosed cable ties (Fig.21).
Installation completion:
6. Re-insert heat exchanger
7. Then replace front cover and tightly close unit with both upper snap-in hooks
Fig .16
Fig .18
Fig .20
Adhesive socket
7
EN
Fig .17
Fig .19
Fig .21