Sony WEGA KLV-30MR1 Mode D'emploi page 72

Problem
Distorted picture and noisy sound.
Stripe noise during playback/recording of
a VCR.
Poor or no picture (screen is dark), but
good sound.
Noisy picture when viewing a TV
channel.
Distorted picture when changing
programmes or selecting teletext.
Wrong characters appear when viewing
teletext.
Wrong characters appear when viewing
NexTView.
No sound/Noisy sound.
Good picture, no sound.
Audio noise.
The TV fan noise becomes louder.
Cannot operate the menu.
70
Additional Information
Possible remedies
• Check if any connected optional equipment is installed in
front of the TV or at the side of the TV. When installing
optional equipment, leave some space between the optional
equipment and TV.
• Video head interference. Keep your VCR away from the TV.
• Leave a space of 30 cm between your VCR and the display
unit to avoid noise.
• Avoid installing your VCR in front of the display unit or at
the side of the display unit.
• Using the menu system, select the "Picture Adjustment"
menu and select "Reset" to return to the factory settings
(page 27).
• If the PICTURE OFF indicator lights up in blue, press
(picture off) on the remote control.
• Using the menu system, select the "Manual Programme
Preset" option in the "Set Up" menu and adjust Fine Tuning
(AFT) to obtain better picture reception (page 39).
• Using the menu system, set the "NR" (Noise Reduction)
option in the "Picture Adjustment" menu to reduce the noise
in the picture (page 27).
• Turn off any equipment connected to the Scart connector on
the rear of the media receiver unit.
• Using the menu system, enter the "Language/Country"
option in the "Set Up" menu and select the country in which
you operate the TV set (page 36). For Cyrillic languages, we
recommend that you select Russia in case your own country
does not appear in the list.
• Using the menu system, enter the "Language/Country"
option in the "Setup" menu and select the country as the
NexTView is broadcasted (page 36).
%
• Press the 2 +/– or
• Check that "Speaker" option is set to "Main" in the
"Features" menu (page 33).
• If headphones are connected, select the "
option in the "Sound adjustment" menu to "Off," or
disconnect the headphones.
• Make sure that the aerial is connected using the supplied
coaxial cable.
• Keep the aerial cable away from other connecting cords.
• Do not use 300-ohm twin lead cables as interference may
occur.
• The ventilation holes can accumulate dust over a period of
time. the accumulated dust may make the cooling function of
the built-in fan less effective. To prevent this, we recommend
removing the dust periodically (once a month) using a
vacuum cleaner.
• If the item you want to select appears in a pale colour, you
cannot select it.
(mute) on the remote control.
i Speaker Link"