Junker JC Série Notice D'utilisation page 38

en Faults – what to do?
Displays do not illuminate.
The mains plug has not been inserted properly.
The fuse has tripped.
The power has failed.
Display indicates "E...".
Electronics have detected a fault.
The cool-fresh compartment is too warm or too cold.
The standard setting was set too high or too low
(e.g. frost in cool-fresh compartment).
Appliance is not cooling, display and lighting are lit.
Showroom mode switched on.
--------
38
Connect the mains plug.
Check the fuses.
Check whether the power is on.
Call the after-sales service.
~ "Customer service" on page 39
You can set the temperature in the cool-fresh com-
partment 3 settings warmer or colder. If the temper-
ature in the refrigerator compartment is set to the
setting 0, the cool-fresh compartment will have a
temperature close to 0 °C.
Note: Any change to the standard setting will affect
the temperature in the refrigerator compartment and
freezer compartment.
Press and hold the freezer compartment
1.
Super button until the display temperature
refrigerator compartment flashes.
Press the + / – button to change the setting.
2.
Setting –3 corresponds to the coldest setting.
Setting +3 corresponds to the warmest setting.
The selected setting is saved after one minute.
Start the appliance self-test.
~ "Appliance self-test" on page 39
When the programme has ended, the appliance
switches over to normal operation.