Temperature Control - SEVERIN KS 9760 Mode D'emploi

∙ Remove the two spacers (2) on the rear of the unit.
∙ Open the freezer door (18).
∙ Remove the fixing screws (1 and 3) from the top cover
(two screws at the front and two at the rear), and take off
the cover (4).
∙ Unscrew the upper hinge bracket (5) and remove it.
Caution: the door must be supported while this is
done.
∙ Take off the freezer door (18).
∙ Unscrew the hinge pin (7) together with the nut (6) and
washers (8), and fit the entire assembly to the opposite
side of the hinge bracket.
∙ Undo the fixing screws (11) on the centre hinge bracket
(10) and take them off, together with the washers (12).
Caution: Support the door.
∙ Take off the centre hinge bracket (10) together with the
hinge pin washers and the plastic plate (9).
∙ Take off the refrigerator door (13).
∙ Tilt the whole unit towards the rear.
∙ Unscrew the lower hinge bracket (14) and take it off.
∙ Unscrew the hinge pin (15) from the bracket, and re-
insert it from the other side.
∙ Remove both screws on the left of the underside and
replace them on the right.
∙ Fit the lower hinge bracket (14) on the left of the
underside.
∙ Put the washers on the hinge pin.
∙ Remove the cap (19) from the freezer door and the cap
(16) from the refrigerator door and replace them on the
opposite side of the doors.
∙ Take off the caps (17) from the partition between the
refrigerator and freezer compartments and remove the
screws.
∙ Replace both screws on the opposite side and then the
caps.
∙ Fit the refrigerator door (13) onto the pin (15) of the
lower hinge bracket.
∙ Fit the pin of the centre hinge bracket (10), together with
the washers, to the refrigerator door (13).
∙ Fit the centre hinge bracket (10) together with the plastic
plate (9).
∙ Remove both screws from the upper left and replace
them on the right.
∙ Place the freezer door (18) onto the pin of the centre
hinge bracket (10).
∙ Fit the pin of the upper hinge bracket (5) to the freezer
door (18), and then fit and secure the upper hinge
bracket (5).
Note: If necessary, the alignment of the doors can be
adjusted by slightly loosening the hinge bracket screws,
but remember to tighten them afterwards.
∙ Replace the top cover (4) and use the screws (1 and 3)
to secure it (two screws at the front and two at the rear).
∙ Fit the two enclosed spacer elements (2) into the
corresponding guide slots on the rear).
If the unit has been tilted to more than 30°, wait for
about 4 hours before re-connecting it to the mains.

Temperature control

The unit is re-activated by connecting it to the mains. It is
only switched off completely when the plug is removed from
the wall socket.
The temperature in the refrigerator cabinet can be adjusted
by setting the temperature control. Turning the control
clockwise will decrease the temperature, while turning it
anti-clockwise will increase it.
The medium settings are usually most suitable for home
use.
We recommend using a thermometer to check the actual
temperature inside the cabinet and make adjustments as
necessary.
Following a power interruption, or if the unit has been
switched off on purpose, it may take 3 to 5 minutes before
it switches on again.
In position '0', the cooling function is switched off,
though the appliance is still connected to the mains.
17