Initial Start-Up; Emergency Opening - Häfele 917.37 Série Instructions D'utilisation

4. Installation
4.1 Installation
requirements
4.2 Installation
description

4.3 Initial start-up

5. Clearing locking authorisation
5.1 Clearing the
locking
authorisation of
individual keys
5.2 Clearing the
locking
authorisation of all
keys/Procedure
with lost key

6. Emergency opening

7. Storage
Access control system
The components of the access control system are delivered in a package and are
coordinated with each other. Components from different packages will not work in
combination.
Door leaf
Suitable materials: Wood, wooden materials, plastic and metal
Mortise lock
• Mortise lock in compliance with DIN 18251.
• Lever handle sets are suitable for the mortise lock.
See instructions starting on page 32.
Pay attention to the following instructions during installation:
• Do not close the door during installation and initial start-up. It cannot be opened
from the outside until installation and initial start-up are complete.
• Insert and adjust the product components without using force.
• Tighten screws by hand.
• Use special tools to open the knobs.
See instructions starting on page 32.
See instructions starting on page 38.
If a user key is lost, all user keys must be cleared.
See instructions starting on page 38.
After clearing all user keys, all of the required user keys must have locking
authorisations assigned to them again.
See instructions starting on page 39.
In the event of a fault, the access control system must be removed by trained experts
(key service).
• Keep programmed access control system at least 10 cm away from the keys
(transponder), since contact will otherwise occur and the batteries will be
discharged.
• Cylinders with batteries in them must not be stored together, since the cylinders
will switch each other on and the batteries will be discharged.
11