Installation Instructions; Ceiling Installation; Wall Installation - ADEO SCREEN MAX ONE Manuel D'installation

ENGLISH – Rolling screen installation and operation manual
WARNING: It 's absolutely forbidden to install the screen on mobile walls or unstable cables,the brackets must be applied on surfaces that ensure in the time your distance. When
installing the screen use plugs and screws suitable for the screen's weight and for the type of wall or ceiling on which the mount brackets are to be fixed, based on the following criteria
Screen width up to cm
Overall weight
Secure the brackets to the ceiling or wall considering a maximum distance of 5 cm from the screen's lateral edges, as shown in the picture on the left.

CEILING INSTALLATION

Proceed as described in picture 1, bring the screen close to the brackets (pos.1); block the rear part of the screen by tilting it slightly (pos.2); push the screen upwards until it
slides into the bracket (pos.3); tighten the three screws on the bracket as far as they will go (pos.4).

WALL INSTALLATION

Proceed as described in picture 2, bring the screen close to the brackets (pos.1); block the rear part of the screen by tilting it slightly (pos.2); push the screen upwards until it
slides into the bracket (pos.3); tighten the three screws on the bracket as far as they will go (pos.4).
FIG. 1
ATTENTION!
AFTER CORRECT INSTALLATION OF THE SCREEN REMOVE THE PLASTIC BAND WICH BLOCKED THE LOWBAR
Made by Adeo Screen sp. Z o.o. (Poland) Specifications are subject to change without notice. E&OE
Doc: MAX ONE Installation Manual rev2 | 12.06.2017
Please verify that you are working with the latest revision of this document before specifying your screen.

07 INSTALLATION INSTRUCTIONS

160 200
Kg 20 Kg 25
FIG. 2
08 COUNTERWEIGHT TENSIONING ADJUSTAMENT
250 300 360 410
Kg 30 Kg 35 Kg 45 Kg 50
520 620 720
Kg 100 Kg 150 Kg 200
Page 9